Preview Questions Assembler | Role Specific Skill

Question 1: How can an Assembler address the challenge of working with components that have varying tolerances during assembly?

Which action should you take?

Choose only one option

By relying on final inspection to identify tolerance issues

By skipping quality control checks for components with varying tolerances

By ignoring tolerance differences and forcing components together

By adjusting assembly techniques and using measurement tools to ensure precise fitment

Question 2: What is the proper procedure for disposing of materials that are considered hazardous after assembly?

Which action should you take?

Choose only one option

By discarding materials in the regular trash to save time

By following the facility's waste disposal protocols, labeling hazardous materials, and using designated containers

By storing hazardous materials in any available container until disposal

By mixing hazardous materials with non-hazardous materials to simplify disposal

Question 3: How do you properly use a caliper to measure the dimensions of a workpiece?

Which action should you take?

Choose only one option

Adjust the caliper, place it around the workpiece, and take the reading

Place the caliper over the piece without adjustment

Adjust the caliper to the piece, then check the alignment

Always measure from the center of the piece

Question 4: How should an Assembler "verify the calibration of machines or tools before beginning the assembly process"?

Which action should you take?

Choose only one option

Check the calibration settings against the manufacturer's specifications and adjust as needed

Use the machines or tools regardless of their calibration status

Ask the supervisor to check the calibration, but do not verify it personally

Assume that the machines or tools are calibrated and start working immediately

Question 5: What is the proper procedure when using pliers to cut wires?

Which action should you take?

Choose only one option

Ensure the wire is positioned properly and apply slow pressure

Use the wire cutters for sharp, quick cuts

Press hard and quickly for maximum speed

Position the wire in the middle of the pliers

Question 6: What type of hand tool is best suited for driving fasteners in confined spaces?

Which action should you take?

Choose only one option

Ratchet wrench

Power drill

Ball-peen hammer

Flathead screwdriver